How to Install a 2-Post Car Lift


If you’re wondering how to install a 2-post car lift, read on! The basic steps include installing a concrete slab, anchors, and safety devices. Also, make sure the slab is at least four inches thick and has at least three-and-a-half inches of embedment. Click this over here now to add gravel under the slab. In addition, a hefty price tag can add up.

Concrete slab thickness of at least 4 inches

For safe, long-term operation of your 2-post car lift, you should install it on a concrete slab with a minimum thickness of four inches. This allows for proper reinforcing within the concrete before it sets. Reinforcing is necessary for different kinds of structures, including garage doors and heavy machinery. If you’re installing the car lift on a concrete slab, you should check the psi rating of the concrete to ensure it’s appropriate for the lift.

The proper foundation for a two-post car lift is the thickness of the slab. The slab should be at least four inches thick, and at least six inches deep. For vehicles weighing under 9,000 pounds, a 4″-thick slab should be adequate. Installing the lift on two concrete footings makes it easier to work with. When you install the lift, you should ensure that the columns are spaced six inches apart from the edge of the slab. Do not install the columns over cracks in the slab.

Installation of safety devices

Listed below are the essential safety features on a 2 post car lift. Cable slack detection is a necessary feature. During the lift’s raise and lower movements, the safety locks engage with the lift structure. They prevent sudden free falls if the suspension fails. It’s essential to connect the safety locks and cables with top-quality equalization cables. Also, look for certified direct-drive systems. Don’t focus on the brand name of the lift, but rather research the most trusted names in the industry.

Load-holding devices must engage in the same way. They should be released automatically when the lift is in a safe, lowered position. When engaging, the mechanical safety latches must engage as well. The same is true for the lifting chain and synchronisation cable. Regardless of manufacturer, these features are crucial for safe lift operation. Listed below are some of the key features to look for when buying a 2 post car lift.

Adding gravel under your slab

If you’re going to add a 2 post car lift to your garage floor, you’ll need to make sure the surface is level. You can do this by adding four inches of gravel or stone under the concrete slab before pouring it. This will ensure that the slab doesn’t crack when the weight of the car lift rests on top of it. Remember to use the recommended amount of gravel to avoid any problems.

The first step to constructing the slab is to set up the foundation. Using a string line, mark the corners and lay four 2″x12″s. Mark the level and slope of the slab. You may need to add some gravel to create a level base, but it will make your work a lot easier. Adding gravel is a great way to prevent water seepage while also slowing down the drying process. Once you’ve made sure your foundation is level, call around and get prices for concrete and gravel. Remember to book ahead for delivery and equipment rentals.

Overheating your car lift

Before you begin working with your 2 post car lift, make sure you read the instructions. Depending on the manufacturer, the manual may differ slightly. You should also read the instructions for the type of lift you’re using. Then, follow those instructions. Overheating your lift can cause it to malfunction. Read the manual carefully so you don’t end up damaging the lift. Also, pay attention to the installation instructions if you don’t want to risk damaging the car.